Precautions of Water Slides for Water Park Operators

More or Less, the climax of power consumption unstabilizes the electric voltage to fall short for 220V. Always be alert to the warning that no voltage less than 210V is applicable to any kinds of electrical equipment. Otherwise, heat the motor and burn the equipment, then upset the normal operations and suffer the profits (Especially for the water purification equipment, all the electrical wires must not be no less than 2.5 square, no connection in series, no use of other high-frequency motors simultaneously, no loosened motor wire connection and no half-way stripped rubber.). Forever be 220V constant voltage.

Mind the heat dissipation of mechanical and electrical facility. The Fan can work continuously for 7 to 8 hours in 30 °C according to the test. Otherwise, higher than 30 °C, stop the fan or replace with a new one (Several backup fans are suggested for each water slide equipment.) Make sure that all electric wires are waterproof.

Regular deterge the water for all amusement equipment to make it qualified with the national standards. A successful operation leaves no room for the penny wise and pound foolish.

Pay close attention to exposed wires and sockets and fulfill the preventive measures of slippery-proof and anti-theft, etc. Failures here cost a lot and infamize the water park, which never is too cautious.

It is a must to have all equipment under professional supervision and evacuation. Responsible takers are needed for each equipment to supervise the order and guide the steps. Only one player, rather than two or more, shall be on each slide for one time, that is, the later should wait for the former on the top, where there are no more than two at the same time, to reach the bottom to start.

Assured normal and safe conditions of all equipment shall be achieved by over-all inspections for each switch-on. Daily comprehensive inspection should be taken by professionals for several times to relieve potential hazards, which, once discovered, calls for an immediate solution. Only by the fault excluded can the equipment be restarted to put into service. All fans, motors, wires, plugs and so on shall be kept by several supervisors without the reach of players to exempt them from the risk of electric shock. Professional electricians should strictly check for an active the automatic power-off device for the cabinet and the non-leakage of electric several times a day. Otherwise, any abnormity requires prompt solutions. Only by the solution tested to work can the equipment be put into use.

The bad weather and the dark go against the normal usage. It is prohibited to use the outdoor water slide under adverse weather like 3-force wind or above, thunder, rain and snow. All equipment shall be firmly secured with no overs for capacity, load, height and weight. A single device is prohibited to have more than 2 players with a total weight exceeding 120kg.

All water slide equipment must be checked and fixed before it is put into service. Check the parts to be fixed with each other, the stands to be fastened with the ground and the wind-guard ropes to be firmed with the holders. The water park is ready to be enjoyed with, given the prerequisite that all equipment is all-round secured. Regular inspections are the safety guarantee for water slides. For any abnormal occurrence such as leakage or breakage, halt at once.